MATERIAL SAFETY DATA SHEET
Essentially Similar to U.S. Department of Labor Form OSHA
Revised Date: 12/11/08
SECTION I-Product Information
Manufacturer: Max Professional
24 Hour Emergency Phone Number: 800-424-9300
Product Name: Max Professional All
Purpose Cleaning Wipes
SECTION II-Composition / Information on Ingredients
Chemical
characterization
Description: Mixture of substances listed below with
nonhazardous additions. For the wording
of the listed of the listed risk phrases refer to section 16.
Propan-2-ol
CAS# 67-63-0
Ethanol
CAS# 64-17-5
1-
[1, 3 – bis (hydroxymethyl)-2,
5-dioxoimidazolidin-4-yl]-1, 3-bis (hydroxymethyl) urea CAS# 78491-02-8
1,
3-bis (hydroxymethyl)-5, 5-dimethylimidazolidine-2,
4-doine
CAS#
6440-58-0
P-menth-1-en-8-ol
CAS# 98-55-5
Water,
distilled, conductivity or of similar purity
CAS#
7732-18-5
SECTION III-Hazards Identification
Hazard
description: F
Highly flammable
Information concerning particular hazards for human
and environment:
The
product has to be labeled to the calculation procedure of the ÒGeneral
Classification guideline for preparations of the EUÓ in the latest valid
version.
Classification
System:
The
classification is according to the latest editions of the EU-lists, and
extended by company and literature data.
SECTION IV-First Aid Measures
After
inhalation:
supply fresh air; consult doctor in case of complaints.
After
skin contact: Generally
the product does not irritate the skin.
After
eye contact:
Rinse opened eye for several minutes under running water. Then consult a
doctor.
After
swallowing:
If Symptoms persist consult doctor.
SECTION V-Fire-Fighting measures
Suitable: extinguishing agents: CO2, sand extinguishing powder. Do not
use water.
For safety reasons unsuitable extinguishing
agents:
Water with full jet.
Protective equipment:
Wear fully protective device.
Mouth respiratory protective device.
Do
not inhale explosion gases or combustion gases.
SECTION VI-Accidental Release
Measures
Person-related safety precautions:
Wear protective equipment. Keep
unprotected persons away.
Measures for environmental protection:
Don
not allow product to reach sewage system or any water course.
Inform respective authorities in case of
seepage into water course.
Do
not allow to enter sewers/ surface or ground water.
Measures for cleaning/collecting:
Absorb
with liquid-binding material (sand, diatomite, acid binders, and sawdust).
Ensure
adequate ventilation.
Do not flush with water or aqueous
cleansing agents.
SECTION VII-Handling and Storage
Handling:
Information
for safety handling: Store in a
cool, dry place in tightly closed receptacles.
Information
about fire-and explosion protection:
Keep
ignition sources away- Do not smoke
Protect
against electrostatic charges.
Storage:
Requirements
to be met by storerooms and receptacles:
Store in a cool condition.
Information
about storage in one common storage facility: Store away from flammable
substances.
Further
information about storage conditions: Keep container tightly sealed.
Trade
name: All purpose wipes
Store
in cool, dry, conditions in well sealed receptacles.
SECTION VIII-Exposure Controls / Personal
Protection
Additional
information about design of technical facilities: No further data; item 7.
Ingredients
with limit values that require monitoring at the workplace: 67-63-0 propan-2-ol
WEL (Great Britain)
Short-term
value: 1250mg/m³, 500 ml/m³
Long-term value: 999 mg/m³, 400 ml/m³
PEL (USA) Short-term value: 1225
mg/m³, 500 ml/m³
Long-term value: 980 mg/m³, 400 ml/m³
TLV (USA) Short-term value: 984mg/m³, 400ml/m³
Long-term value: 492 mg/m³,
200ml/m³
Additional information:
The lists valid
during the making were used as basis.
Personal protective
equipment: Wash
hands before breaks and at the end of work.
Respiratory protection: Suitable respiratory
protective device recommended.
Protection of hands:
Protective gloves:
The glove material has to
be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no
recommendation to the glove material can be given for the product/ the
preparation/ the chemical mixture.
Selection of the glove
material on consideration of the penetration times, rates of diffusion and the
degradation.
Material of gloves:
The selection of the
suitable gloves does not only depend on the material, but also on further marks
of quality and varies from manufacturer. As the product is a preparation of
several substances, the resistance of the glove material can not be calculated
in advance and has therefore to be checked prior to the application.
Penetration time of glove
material:
The exact break through
time has to be found out by the manufacturer of the protective gloves and has
to be observed.
Eye protection:
Tightly
sealed goggles
SECTION
IX-Physical and Chemical Properties
General Information
Form:
Flakes
Colour:
White
Odour:
Aromatic
Change in condition:
Melting point/Melting
range: Not available
Boiling point/Boiling
range: Not available
Flash point:
Not available
Flammability (solid,
gaseous): Not available
Ignition temperature:
Not available
Self-igniting:
Product is not self
igniting
Danger of explosion:
Product is not explosive,
However, formation of explosive air/vapour
mixtures are possible.
Explosion limits:
Lower:
Not available
Upper:
Not available
Oxidizing properties
Not available
Vapour pressure: Not
available
Density:
Not available
Relative density:
Not available
Vapour density:
Not available
Evaporation rate:
Not available
Solubility in / Miscibility
with
Water:
Not available
PH-value:
Not available
Viscosity:
Dynamic: Not available
SECTION X-Stability and Reactivity
Thermal decomposition /
conditions to be avoided: No
decomposition if used according to specifications.
Dangerous reactions: No
dangerous reactions known.
Dangerous decomposition
products: No dangerous decomposition products known.
SECTION XI-Toxicological
Information
Acute Toxicity:
LD/LC50 values relevant for
classification:
57-55-6 popane-1, 2-diol Oral
LD50
2000 mg/kg (rat)
Dermal LD50 20800
mg/kg (rabbit)
98-55-5
p-menth-1en-8-ol
Oral
LD50 4300 mg/kg (rat)
67-17-5 ethanol
Oral
LD50 7060 mg/kg
(rat)
Inhalative
LC50/4 h
20000 mg/l (rat)
67-63-0 propan-2-ol
Oral
LD50 5045 mg/kg
(rat)
Dermal LD50 12800 mg/kg
(rat)
Inhalative
LC50/4 h 30mg/l
(rat)
Primary irritant effect:
On the skin: Irritating
effect possible.
On the eye: Irritating
effect possible.
Sensitization:
Sensitization possible.
SECTION XII-Ecological
Information
General: Water
hazard class 1 (German Regulation) (Self-assessment): slightly
SECTION XIII-Disposal Considerations
Product:
Recommendation:
Must not be disposed together with household garbage. Do not allow
product to reach sewage
system.
Uncleaned Packaging:
Recommendation:
Disposal must be made according to official regulations.
SECTION
XIV-Transport Information
Land transport ADR/RID
(cross-border)
ADR/RID class:
3 flammable liquids.
Danger code (kemler)
33
UN-Number:
1993
Packaging group:
II
Hazard label:
3
Description of goods:
1993 FLAMMABLE LIQUID, N.O.S. (ISOPROPANOL (ISOPROPYL ALCOHOL))
Maritime transport IMDG:
IMDG Class:
3
UN Number
1993
Label:
3
EMS Number:
F-E, S-E
Marine pollutant:
Yes
Proper shipping name:
FLAMMABLE LIQUID, N.O.S (ISOPROPANOL (ISOPROPYL ALCOHOL))
Air transport ICAO-TI and
IATA-DGR:
ICAO/IATA Class:
3
UN/ID Number:
1993
Label:
3
Packaging group:
II
Proper shipping name: FLAMMABLE LIQUID, N.O.S. (ISOPROPANOL (ISOPROPYL ALCOHOL))